First you need to prepare tools and devices, you will certainly need a table, because it is on it that preparations are undergoing for wallpapering. It is worth noting the height of the room, add a couple of centimeters, and you can safely cut the first lane.
It is advisable to cut the second strip without delay, not forgetting to take into account what the picture is shifted. For those who stick wallpaper for the first time, it is better to cut the strips as they overlay them. This is a little more painstaking, but it will help prevent mistakes.
The wallpaper stripes are best covered with glue. It is best to start applying it from the middle to the edge and you need to add it with glue to the glue, this will extend the gluing time and helps it penetrate the basis of the wallpaper.
In order to lay the wallpaper on the wall, you need to open the half of the strip that is higher. Then you need to level the longer edge and leave a couple of centimeters of the output for the cut at the top. The wallpaper is pressed with the hands and so that the air bubbles do not arise are smoothed with a rag, spatula, roller or brush. The second half of the strip is smoothed and glued in the same method.
The next strip is glued given the combination of the pattern at the seams. In order not to be visible joints, it is recommended to use the “barrel” roller.
The upper and lower edges of the wallpaper are cut off, and the excess glue is immediately eliminated by the sponge.